![]() With steering wheel level, wheels pointing straight ahead, make sure G85 is reporting 0 degrees +/- 5 degrees. ![]() The Initialization will usually take place during a test drive.Ġ0778 - Steering Angle Sensor (G85): Faulty Check the Measuring Value Blocks (MVB) in the Steering Aid Control Module (J500 / #44) for details. This Fault Code may also be stored even though the Steering Angle Sensor (G85) is properly calibrated (Basic Setting), though it may not be finally initialized yet. Perform Steering Angle Sensor (G85) Basic Setting See Vehicle specific Diagnostic Procedures for Details Steering Angle Sensor (G85) Basic Setting lost ![]() To make sure the basic setting was succesful, check the sensor again.Ĭheck field 1, the value has to be between -4.5 and +4.5 °. Keep the engine running and do not switch off the ignition.Įnter 40168, to enable the basic setting.Īfter a successful basic setting, field 2 should say "OK". If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight.Įnsure that the steering wheel is not moved again. ![]() Turn the steering wheel one turn to the right and one turn to the left.ĭrive in a short distance straight line on a level surface at a speed not higher than 20 km/h. Tens vários erros possíveis, o erro não especificava mais nada?
0 Comments
Leave a Reply. |